iPods are a good invention, however many have complained about the shortage of playtime and poor battery life. Previously, replacing an iPod battery was next to impossible. So once your battery dies, its here we are at a brand new iPod. This in fact proved being extremely expensive. Consequently, manufacturers have begun producing aftermarket iPOD batteries for any DIY conscious producer. There will be even high capacity batteries which can basically offer you more playtime in your iPod as compared to an original iPod batteries. A good better incentive to exchange that dying battery!

I really know what you’re thinking, you don’t would you like to rip apart that shiny iPod of yours! Aftermarket iPod batteries were designed to help make the installation as easy as possible (it wasn’t really everything difficult to start with anyway). Because the batteries installation doesn’t require any soldering, possibly the most difficult part is opening in the physical case. Because the iPod doesn’t contain any screws, the casing should be pried off in an effort to access the internal battery. I don't recommend employing a screwdriver to make this happen as It'll damage the case. A guitar pick is recommended to get the job done, but more appropriate, some batteries come using the non scratch nylon tools needed to open your iPod safely.

Below are a few instructions for you to install your battery. I know that there will be greater than one
Steps to install the battery :

• Lay your iPod on the part of cloth o non scratch surface. Playing with your non scratch tools, slowly insert it underneath the cover and initiate to pry off of the cover. You ought to hear it commence to open. Work the path by sliding the tool all close to the edges.


• The iPod is basically made of two halves. With both halves separated, place the empty shell aside.


• Another half may have all of the internal components in there. You ought to be in a position to spot the battery in there. You'll see the battery is connected to the most circuit board of one's iPod. Carefully unplug the old battery by pulling on finished from the connector.


• Get the new battery and plug-in straight into the connector socket in your iPod’s circuit board. The connector will only be put into one way so do ensure you insert it the proper way up.


• Once it’s all connected up, place the cover back on by pressing the edges of the 2 halves together.


• Plug your charger in and let the new iPod charge up for a minimum of 4 hours. All new batteries should have a longer than normal charge initially around.


• Now you’re able to enjoy your music yet again!

 

Home

About Me

Contact Me

Privacy Policy

Articles